• My Account
  • My Cart
  • Checkout
  • Home Products Features FAQ's Installation About Us Contact
    Shopping Cart

    BumpTek - Corner Bumper Guard Installation Guide


    PRE-INSTALLATION NOTES
    Please Read All Instructions and Warnings Before Using Product.

    (1) Do not wash vehicle for 24 hours following installation of corner bumper guards
    (2) Area of application must be clean, dry and wax free.
    (3) If temperature is below 60 degrees F, heat the double sided tape and bumper surface to a temperature of 80 degrees F.
    (4) Not recommended for use on unpainted bumpers.

    INSTALLATION GUIDE

    corner bumper guard

    corner bumper protector corner bumper protectors corner bumper protection
    STEP 1:
    Wash install location thoroughly. Use provided alcohol pads to prep install surface.


    STEP 2:
    Peel back red liner and attach gently. NOTE: DO NOT PRESS DOWN FIRMLY UNTIL SATISFIED WITH POSITIONING.
    STEP 3:
    Press down firmly along edges for 10 seconds. Once attached product may be difficult to remove without damaging product.
    STEP 4:
    Admire your new bumper guards. Do not wash vehicle for 24 hours following installation.



  • Quality Corner Bumper Protection
  • OEM Design Bumper Protectors
  • Matte Finish Will Not Chip or Peel
  • Premium 3M Adhesive For Durability
  •  
  • Home
  • About Us
  • Products
  • Shipping
  • Order Status
  • FAQ
  • Terms
  • Privacy
  • Contact Us
  • © 2012 http://www.BumpTek.com - All Rights Reserved. Resources